Install filter on cold water only.
Do not use on water lines exceeding 100 degrees F (38 degrees C).
Water pressure minimum is 25 psi and the maximum is 125 psi.
Protect unit from direct sunlight
and freezing temperatures. Keep above 35 degrees F.
Avoid exposure of filter housing to
Do not use pipe dope or similar
compounds. They can ruin plastic. Use Teflon tape to seal pipe thread
Keep unit clean with soap and
water. Do not use spray cleaners or insecticides near unit.
Intended for indoor, non-commercial
For extended periods of non-use
turn the water off and remove the filter cartridge. Place the
cartridge in a plastic bag, seal, and refrigerate.
Safety glasses must be worn during
Tubing and hose dimensions are
based on outside diameters (OD).
For water line sizes other than those listed, consult a plumber or
Before using the water, flush the
new filter for 30 minutes.
Run drinking or cooking water for 5
- 7 seconds prior to collecting the water for use.
Change cartridge stated at
manufacturer's suggested interval or sooner is you notice a change
in color, taste or low water pressure.
Filter is not a water purifier and
is not intended for use with contaminated water.
Comply with all state and local
laws regarding the installation of water treatment devices.
Do not use with water that is
microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
The rubber O-ring provides the
water tight seal between the cap and the housing. It is important that
the O-ring be properly seated in the groove in the housing or a water
leak could occur.
The contaminants or other
substances removed or reduced by this water filter device are not
necessarily in your water.
Use of ANY cartridge other
than an Omni filter will void your warranty.
Replace tank O-ring with every
second filter cartridge change.
DO NOT use wrench to tighten
Use wrench ONLY for tank